Dension DAB+P Anleitung zur Fehlerbehebung PDF herunterladen (Seite 44)

Troubleshooting Guide for Installing Dension Products

G. Installation/Programming issues:

When installing a Gateway 500 Lite, please do not forget (!):

- Gateway must be the last connected device on the MOST ring, or other devices like Amplifier,

Phone, Navigation, etc. will not be accessible when the Gateway is active

- Factory CD-Changer cannot be retained

- Programming required if factory CD-Changer option was not set – on BMW, Mercedes,

Porsche and Saab

- double check the light directions on the MOST ring

- power needs to be constant/permanent 12V

- take care because BMWs have 2 different kinds of switched power – one of them goes OFF

immediately as soon as the key is removed from the ignition – the other goes OFF after 15

minutes (!)

- There is no DIP switch, therefore it requires an additional USB configuration (default setting is

Mercedes)

In case of BMW for Programming we recommend Autologic or other 3

party enabler (NCS expert).

Using the factory programmer is not recommended because it can be done if manual programming

mode selected. You can use the factory computer for all other brands.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51

Keine Kommentare

Dension DAB+P Anleitung zur Fehlerbehebung Seite 44